Home > Just for you > How to Install Drywall – For the Beginners! > Page 2

How to Install Drywall – For the Beginners!

how to install drywall for the beginners, diy, home improvement, how to

The next thing you need to do is measure the space that you need to place drywall in. It’s really important to measure the length and width but also measure the width at a few spots within the length.
With any projects, nothing is usually perfect and that’s what we have found when measuring our drywall.

how to install drywall for the beginners, diy, home improvement, how to

Once you have your measurements, diagram it out so that you remember.

how to install drywall for the beginners, diy, home improvement, how to

Place your drywall white side up and mark your measurements. Use a straight edge (in our case a piece of baseboard trim) to draw your lines for your cut.

how to install drywall for the beginners, diy, home improvement, how to

Using a utility knife, score your drywall. You don’t want to press completely through your drywall, but you want to press firm enough to score it evenly down your line

how to install drywall for the beginners, diy, home improvement, how to

From the backside, give it a good knee bump and it will cut in half where you scored it.

how to install drywall for the beginners, diy, home improvement, how to

t usually doesn’t have a clean break, so at this time, we cut through the back paper to finish it off.

how to install drywall for the beginners, diy, home improvement, how to

Take it in and test it out in your spot.

how to install drywall for the beginners, diy, home improvement, how to

Many times, it is just a smidgen too wide and that’s when you want to use a drywall rasp. This will sand it down enough so that you can get it to fit within the space.

how to install drywall for the beginners, diy, home improvement, how to

Once it fits, use the drywall screws and dimpler bit to put the screws in to studs. The bit stopper will allow you to put the screws in at the perfect length, helping you protect the drywall from cracking (which happens when your screw goes in too far).
Admire how good it looks. Just kidding! Actually, to be honest, this is a HUGE improvement from looking at bare studs so, if you made it this far, then consider it a success.
The next step is mudding the seams, but we haven’t go there yet. I’ll share when we do!