Design Your Own Plastic Spoon Lamp

Cut the spoon but not to short so you can melt it and glue it. You can always cut of a piece after melting. After iI melt it, i let it cool down on the surface I am going to glue it on. If you’re to slow, heat it again and start all over again. When you cool it of on the surface, it takes the perfect shape or curve. Watch your fingers when you glue the spoons. HOT !!

Choose your shape. Pinapple or feathers like. Spoons up or down. The look is completely different. Cut All your spoons. Then melt one by one and glue immediatly around and around and so on. glue on glass Is difficult. it might come of. Use more glue

If you use a powder container.:The lid becomes the botom. I used coffee spoons for the lid . cut a hole in the lid to ad the holder of the lamp ( pardon my English, it’s not my native tongue)

Use a LED lamp because of the combination plastic and heat . LED has nearly no heat. Make sure you have holes to release heat.

You can spray paint the spoons to get a diffrent look or put a colored LED inside

while watching TV I switch the led lamp to orange to give a relaxing mood

blue light activates your concentration